The system must be shut down before it is unplugged.
Once the system has been shut down, the only way it can be
restarted is by pressing the soft power button on the unit itself.
You must therefore have physical access to the unit if you wish
to be able to restart it after it has been shut down.
Shutting down will cause any active calls and registrations to
be terminated. For this reason, the

Shutdown

page displays

the number of current calls and registrations, so you can check
these before you shut down.

If you do not shut down the system immediately, you
should refresh this page before shutting down to check
the current status of calls and registrations.

Shutdown System

Click here to shut down the system.
The

Shutting Down

page will appear. This page will remain in

place once the system has successfully shut down but any
attempts to refresh the page or access the VCS will then be
unsuccessful.

Do not shut down the system while the red ALM LED on
the front of the box is on. This indicates a hardware
fault. Contact your TANDBERG representative.

Overview

To shut down the VCS:

Maintenance > Shutdown

•

You will be taken to the

Shutdown

page.