Restoring default configuration, Overview, Defaultvaluesset level 3 – TANDBERG D14049.04 User Manual
Page 191: Overview defaultvaluesset level 3, Restoring the system to its default setting
191
D14049.04
JULY 2008
Grey Headline (continued)
TANDBERG
VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Restoring Default Configuration
DefaultValuesSet Level 3
It is possible to restore the VCS to its default configuration. This
is done via the CLI using
. This
command is not available via the web UI.
The
DefaultValuesSet
command allows you to specify the
level of configuration to restore, from 1 to 3 as follows:
Level 1
•
resets most configuration items to their default value,
with the exception of the items shown in the table opposite.
The
table shows a full list of all
configuration items and where applicable their default values.
Level 2
•
is not currently used, so setting this level has the
same effect as setting Level 1.
Level 3
•
resets all configuration items to their default value,
including those shown in the table opposite.
Configuration item
Default value after
xCommand DefaultValuesSet Level: 3
TANDBERG
IPv4
127.0.0.1
Auto
192.168.0.100
Ethernet [1..2] IP V4 SubnetMask
255.255.255.0
Off
public
0
tms/public/external/management/SystemManagementService.asmx
Policy AdministratorPolicy Mode
Off
Local
Policy UserPolicy Server Protocol
HTTP
Policy UserPolicy Server Address
Policy UserPolicy Server UserName
Policy UserPolicy Server Password
Overview
!
xCommand DefaultValuesSet Level: 3
must be
used with caution, as it resets the system’s IPv4 and
IPv6 addresses, meaning you will no longer be able to
access the system over IP. It also deletes all option keys
including pre-installed options such as Expressway and the
number of registrations and calls.