TANDBERG D14049.04 - Manual (Page 233)

233
D14049.04
JULY 2008
Grey Headline (continued)
Zones LocalZone Traversal H323 H46018 Mode:
Determines whether or not H.323 calls using H460.18 mode for firewall traversal will be allowed. Applies to traversal-enabled endpoints registered directly with the VCS.
Default: On
Example: xConfiguration Zones LocalZone Traversal H323 H46018 Mode: On
Zones LocalZone Traversal H323 H46019 Demultiplexing Mode:
Determines whether the VCS will operate in Demultiplexing mode for calls from traversal-enabled endpoints registered directly with it.
On : allows use of the same two ports for all calls.
Off : Each call will use a separate pair of ports for media.
Default: Off
Example: xConfiguration Zones LocalZone Traversal H323 H46019 Demultiplexing Mode: Off
Zones LocalZone Traversal H323 Preference:
If an endpoint that is registered directly with the VCS supports both Assent and H460.18 protocols, this setting determines which the VCS uses.
Default: Assent
Example: xConfiguration Zones LocalZone Traversal H323 Preference: Assent
Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a TCP probe to the VCS once a call is established, in order to keep the
firewall’s NAT bindings open.
Default: 20
Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: 20
Zones LocalZone Traversal H323 TCPProbe RetryCount: <1..65534>
Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a TCP probe to the VCS.
Default: 5
Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryCount: 5
Zones LocalZone Traversal H323 TCPProbe RetryInterval: <1..65534>
Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a TCP probe to the VCS.
Default: 2
Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryInterval: 2
Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: <1..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a UDP probe to the VCS once a call is established, in order to keep the
firewall’s NAT bindings open.
Default: 20
Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: 20
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Appendices Applications Maintenance
Command Reference - xConfiguration