TANDBERG D14049.04 - Manual (Page 239)

239
D14049.04
JULY 2008
Grey Headline (continued)
Zones Zone [1..200] Neighbor SIP Transport:
Determines which transport type will be used for SIP calls to and from this neighbor.
Default: TCP
Example: xConfiguration Zones Zone 1 Neighbor SIP Transport: TCP
Zones Zone [1..200] SIP Mode:
Determines whether SIP calls will be allowed to and from this zone.
Default: On
Example: xConfiguration Zones Zone 1 SIP Mode: On
Zones Zone [1..200] TraversalClient H323 Port: <1024..65534>
Specifies the port on the traversal server to be used for H.323 firewall traversal calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been
configured in the Traversal Server zone for this VCS.
Default: 2777
Example: xConfiguration Zones Zone 2 TraversalClient H323 Port: 2777
Zones Zone [1..200] TraversalClient H323 Protocol:
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal server.
Note: the same protocol must be set on the server for calls to and from this traversal client.
Default: Assent
Example: xConfiguration Zones Zone 2 TraversalClient H323 Protocol: Assent
Zones Zone [1..200] TraversalClient Peer [1..6] Address :
Specifies the IP Address or Fully Qualified Domain Name (FQDN) of the traversal server. If the traversal server is a VCS Expressway cluster, this will be one of the peers in that cluster.
Example: xConfiguration Zones Zone 2 TraversalClient Peer 1 Address : "10.192.168.1"
Zones Zone [1..200] TraversalClient RetryInterval: <1..65534>
Specifies the interval (in seconds) with which a failed attempt to establish a connection to the traversal server should be retried.
Default: 120
Example: xConfiguration Zones Zone 2 TraversalClient RetryInterval: 120
Zones Zone [1..200] TraversalClient SIP Port: <1024..65534>
Specifies the port on the traversal server to be used for SIP calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been configured in the
Traversal Server zone for this VCS.
Default: 5060
Example: xConfiguration Zones Zone 2 TraversalClient SIP Port: 5060
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Appendices Applications Maintenance
Command Reference - xConfiguration