TANDBERG D14049.04 - Manual (Page 240)

240
D14049.04
JULY 2008
Grey Headline (continued)
Zones Zone [1..200] TraversalClient SIP Transport:
Determines which transport type will be used for SIP calls to and from the traversal server.
Default: TCP
Example: xConfiguration Zones Zone 2 TraversalClient SIP Transport: TCP
Zones Zone [1..200] TraversalServer Authentication UserName:
The name used by the traversal client when authenticating with the traversal server. If the traversal client is a VCS, this must be the VCS’s Authentication User Name. If the traversal client is
a gatekeeper, this must be the gatekeeper’s System Name. For other types of traversal clients, refer to the VCS Admin Guide for further information.
Example: xConfiguration Zones Zone 3 TraversalServer Authentication UserName: "User123"
Zones Zone [1..200] TraversalServer H323 H46019 Demultiplexing Mode:
Determines whether the VCS will operate in Demultiplexing mode for calls from the traversal client.
On : allows use of the same two ports for all calls.
Off : Each call will use a separate pair of ports for media.
Default: Off
Example: xConfiguration Zones Zone 3 TraversalServer H323 H46019 Demultiplexing Mode: Off
Zones Zone [1..200] TraversalServer H323 Port: <1024..65534>
Specifies the port on the VCS being used for H.323 firewall traversal from this traversal client.
Default: 6001, incrementing by 1 for each new zone.
Example: xConfiguration Zones Zone 3 TraversalServer H323 Port: 2777
Zones Zone [1..200] TraversalServer H323 Protocol:
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal client.
Note: the same protocol must be set on the client for calls to and from this traversal server.
Default: Assent
Example: xConfiguration Zones Zone 3 TraversalServer H323 Protocol: Assent
Zones Zone [1..200] TraversalServer SIP Port: <1024..65534>
Specifies the port on the VCS being used for SIP firewall traversal from this traversal client.
Default: 7001, incrementing by 1 for each new zone.
Example: xConfiguration Zones Zone 3 TraversalServer SIP Port: 5060
Zones Zone [1..200] TraversalServer SIP Transport:
Determines which of the two transport types will be used for SIP calls between the traversal client and VCS.
Default: TCP
Example: xConfiguration Zones Zone 3 TraversalServer SIP Transport: TCP
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Appendices Applications Maintenance
Command Reference - xConfiguration