TANDBERG D14049.04 - Manual (Page 230)

230
D14049.04
JULY 2008
Grey Headline (continued)
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode:
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in the Default Subzone.
NoBandwidth : no bandwidth available. No calls can be made to or from the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode: Limited
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within the Default Subzone (applies only if Mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit: 1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode:
Determines whether there is a limit on the bandwidth for any one call between two endpoints within the Default Subzone.
NoBandwidth : no bandwidth available. No calls can be made within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode: Limited
Zones LocalZone DefaultSubZone Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Limit: 500000
Zones LocalZone DefaultSubZone Bandwidth Total Mode:
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any one time.
NoBandwidth : no bandwidth available. No calls can be made to, from, or within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Mode: Limited
Zones LocalZone Match [1..5] Mode :
Determines if and when a query will be sent to the Local Zone.
AlwaysMatch : the zone will always be queried.
PatternMatch : the zone will only be queried if the alias queried for matches the corresponding pattern.
Disabled : the zone will never be queried.
Default: AlwaysMatch (Match 1); Disabled (Matches 2-5)
Example: xConfiguration Zones LocalZone Match [1..5] Mode : PatternMatch
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Appendices Applications Maintenance
Command Reference - xConfiguration