Software configuration, Introduction, Wavelink telnetce – Motorola VC5090 User Manual
Page 231: Citrix ica client, Appendix b: software configuration, Appendix b, software configuration, Appendix b software configuration
Appendix B Software Configuration
Introduction
This chapter provides special instructions required for third-party software that can be used with the VC5090
vehicle computer.
Wavelink TelnetCE
When using a serial scanner in a Wavelink TelnetCE session, the Wavelink Client communications parameters
must be updated to reflect the connection of a scanner to one of the vehicle computer COMM ports. Serial options;
such as baud rate, data bits, stop bits and parity, of the host session and the scanner must match.
The Wavelink Client defaults are:
•
Baud: 9600
•
Data bits: 8
•
Stop bits: 1
•
Parity: None.
Ensure that scanner default parameters match the Wavelink parameters. If they do not, configure the scanner
accordingly. Refer to the scanner Product Reference Guide for information on the default scanner settings.
Citrix ICA Client
To install Citrix ICA Client on the vehicle computer, web services must be disabled.
1.
Turn off CE web services:
a.
Tap
Start
>
Run
.
b.
Enter
CMD
and tap
OK
. The
Command Prompt
window appears.
c.
Enter “
services stop HTP0
:”.
d.
Tap
Enter
.