Motorola VC5090 - Manual (Page 186)

7 - 20 VC5090 Vehicle Computer Product Reference Guide
IPL Error Detection
While receiving data, IPL performs many checks on the data to ensure that the data is received correctly. If an error
is detected, IPL immediately aborts the download, and reports the error on an error screen.
Error screens may vary depending on the action being performed. A sample error screen may look like the screen
pictured below:
Figure 7-22 IPL Error Screen
This error message screen displays until you press any key. Once the screen is acknowledged, IPL returns to the
Initial Program Loader main menu to wait for a new selection.
To find the probable cause of the error, use the error number and/or the error text displayed on the screen to look
up the error in
Table 7-4 .
Downloading:
Platform
via Serial Port 115200
Error # -2: Messages:
Cancelled by user
Press any key to continue
Table 7-4 IPL Errors
Error Text
Error
Number
Probable Cause
Unknown error -1 A general error occurred. Retry the download. If the failure persists, it is
most likely due to a hardware failure; the vehicle computer requires
servicing.
Cancelled by user -2 The user canceled the download.
Can't open the source -7 An error occurred opening the source device (either radio card or Serial
port). Check source device connectivity and retry.
Can't open the
destination -8 An error occurred opening the destination device (either flash ROM or
Power Micro). Retry the download. If the failure persists, it is most likely
due to a hardware failure; the vehicle computer requires servicing.
Can't read from the
source device -9 The source device (either radio card or Serial port) could not be read
from. Check source device connectivity and retry.
Can't write to the
destination device -10 The destination device (either flash ROM or Power Micro) could not be
written to. Retry the download. If the failure persists, it is most likely due
to a hardware failure; the vehicle computer requires servicing.
Transmission checksum
error -11 An error occurred during transmission from the source device (either
radio card or Serial port) and the checksum check failed. Check source
device connectivity and retry.