Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 90
DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
90
•
Door Contact –
You can set the door sensor as remaining closed or remaining open. Usually, it is
remaining closed.
•
Exit Button Type –
You can set the exit button as remaining closed or remaining open. Usually, it is
remaining open.
•
Open Duration –
After swiping the normal card and relay action, the timer for locking the door starts
working.
•
Door Left Open Timeout Alarm –
The alarm can be triggered if the door has not been closed in a
configured time period. If it is set as 0, no alarm will be triggered.
•
Super Password –
The specific person can open the door by inputting the super password.
5. Click
Advanced
to configure advanced parameters.
•
Extended Open Duration –
The door contact can be enabled with appropriate delay after person with
extended accesss needs swipes her/his card.
•
Duress Code –
The door can open by inputting the duress code when there is duress. At the same time,
the client can report the duress event.
NOTE:
The duress code and super password should be different.
The duress code and super password should be different from the authentication password.
The length of duress code and super password is according the device, usually it should
contains 4 to 8 digits.
6. Click
OK
.
7. (Optional): Click
Copy to
, and then select the door to copy the parameters in the page to the selected
doors.
NOTE:
The door’s status duration settings will be copied to the selected door as well.
Configure Parameters for Card Reader
After adding the access control device, you can configure its card reader parameters.
1.
Click Access Control → Advanced Function → Device Parameter.
2. In the device list on the left, click to expand the door, select a card reader and you can edit the card
reader’s parameters on the right.
3. Edit the card reader basic parameters in the Basic Information page.
NOTE:
The displayed parameters may vary for different access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
Some of the following parameters are not listed in the Basic Information page, click
Advanced
to edit the parameters.