Chapter 4 wiring, 1 terminal description, 2 wire normal device – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 24

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
24
Chapter 4 Wiring
The device supports connecting to the RS-485 terminal, the door lock, the exit button, the alarm output/input
devices, the Wiegand card reader, the access controller, and the power supply. You can wire the peripherals
according to the descriptions below.
If connect the Wiegand card reader with the access controller, the temperature screening terminal can
transmit the authentication information to the access controller and the access controller can judge whether
to open the door or not.
NOTE:
If the cable size is 18 AWG, you should use a 12 V switched-mode power supply. And the
distance between the power supply and the device should be no more than 20 m.
If the cable size is 15 AWG, you should use a 12 V switched-mode power supply. And the
distance between the power supply and the device should be no more than 30 m.
If the cable size is 12 AWG, you should use a 12 V switched-mode power supply. And the
distance between the power supply and the device should be no more than 40 m.
4.1 Terminal Description
The terminals contains power input, RS-485, Wiegand output, and door lock.
The descriptions of the terminals are as follows:
Table 4-1 Terminal Descriptions
Group
No.
Function
Color
Name
Description
Group A
A1
Power Input
Red
+12 V
12 VDC Power Supply
A2
Black
GND
Ground
Group B
B1
RS-485
Yellow
485+
RS-485 Wiring
B2
Blue
485-
B3
Red/Black
GND
Ground
Group C
C1
Wiegand
Green
W0
Wiegand Wiring 0
C2
White
W1
Wiegand Wiring 1
C3
White/Black
GND
Ground
Group D
D1
Door Lock
White/Purple NC
Lock Wiring (NC)
D2
White/Yellow COM
Common
D3
White/Red
NO
Lock Wiring (NO)
D4
Yellow/Green SENSOR
Door Contact
D5
Black
GND
Ground
D6
Yellow/Gray
BUTTON
Exit Door Wiring
D7
Yellow/Black GND
Ground
4.2 Wire Normal Device
You can connect the terminal with normal peripherals.