3 set manual attendance via device, 4 set manual and auto attendance via device – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 57

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
57
Result
When you authenticate on the initial page, the authentication will be marked as the configured attendance
status according to the configured schedule.
Example:
If the
Break Out Schedule
is set as Monday 11:00, and the
Break In Schedule
is set as
Monday 12:00, the valid user’s authentication from Monday 11:00 to 12:00 will be marked
as a break.
6.10.3 Set Manual Attendance via Device
Set the attendance mode as manual, and you can select a status manually when you take attendance.
Before You Start
Add at least one user, and set the user’s authentication mode. For details, see
User Management
.
1. Tap
T&A Status
to enter the T&A Status page.
2. Set the Attendance Mode as
Manual
.
Figure 45, Manual Attendance Mode
3. Enable the
Attendance Status
function.
Result
You should select the attendance status manually after authentication.
NOTE:
If you do not select a status, the authentication will be failed and it will not be marked as a
valid attendance.
6.10.4 Set Manual and Auto Attendance via Device
Set the attendance mode as
Manual and Auto
, and the system will automatically change the attendance
status according to the configured parameters. At the same time you can manually change the attendance
status after the authentication.
Before You Start
Add at least one user, and set the user’s authentication mode. For details, see
User Management
.
1. Tap
T&A Status
to enter the T&A Status page.