Chapter 3 installation, 1 installation environment, 2 wall mounting – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 16: 1 flush mounting

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
16
Chapter 3 Installation
3.1 Installation Environment
•
Avoid backlight, direct sunlight, and indirect sunlight.
•
For better identity authentication, there should be light source in or near the installation environment.
•
Sunlight, wind, hot/cool air from air conditioner and other external factors, which may affect surface
temperature, will create the deviation of the temperature measurement. In order to get an accurate
result, make sure the device is applied indoors and windlessly (where is relatively isolated from the
outdoors). The working temperature should keep between 50° and 95° F (10° and 35° C). If there are no
suitable environments for temperature measurement (the area faces the indoor and connects the
outdoor, the area at the door of the indoor environment, etc.), building a temporary temperature
measurement environment is suggested.
•
Influence Factors of Temperature Measurement:
Wind: The wind will take the heat away, which may affect the measurement result.
Sweat: The sweat will take the heat away, which may affect the measurement result.
Air Conditioner (Cool Air): If the indoor temperature is low, the surface temperature may also lower
than the actual temperature, which may affect the measurement result.
Air Conditioner (Heat) or Heating: If the indoor temperature is high, the surface temperature may also
higher than the actual temperature, which may affect the measurement result.
•
In order to make the device work properly, you should wait for 90 min after the device is powered on.
•
For details about installation environment, see
Tips for Installation Environment
3.2 Wall Mounting
3.2.1 Flush Mounting
NOTE:
The hole distance of the gang box is 83.3 mm to 83.5 mm.
The additional force shall be equal to three times the weight of the equipment. The
equipment ad its associated mounting means shall remain secure during the installation.
After the installation, the equipment, including any associated mounting plate, shall not be
damaged.
Select the mounting method according to your actual situation.
1.
Make sure the gang box is installed on the wall.