Netopia CLI 874 - Manual (Page 70)

2-58 Command Line Interface Commands Reference
PVCs
Note: The commands in this section are suppor ted beginning with firmware release 8.3.1.
interface { adsl | sdsl } id pvc { id | tag }
no interface { adsl | sdsl } id pvc { id | tag }
show interface { adsl | sdsl } id pvc { id | tag }
These commands allow you to set, disable, or show a permanent vir tual circuit. You can specify an optional
circuit tag of up to 14 ASCII characters. The tag is used only to identify the circuit for management purposes,
and has no significance on the wire; it is merely a convenience to aid in selecting circuits from lists. The default
circuit name is “Circuit ”, where is replaced with a single decimal ASCII digit (between one and eight)
corresponding to the circuit’s position in the list of up to eight circuits.
tag
interface { adsl | sdsl } id pvc { id | tag } tag tag
show interface { adsl | sdsl } id pvc { id | tag } tag
These commands allow you to set or show a permanent vir tual circuit identified by tag.
PVC Configuration Commands
interface { adsl | sdsl } id pvc { id | tag }
no interface { adsl | sdsl } id pvc { id | tag }
show interface { adsl | sdsl } id pvc { id | tag }
interface { adsl | sdsl } id pvc { id | tag } tag tag
show interface { adsl | sdsl } id pvc { id | tag } tag
interface { adsl | sdsl } id pvc { id | tag } enable { yes | no }
no interface { adsl | sdsl } id pvc { id | tag } enable
show interface { adsl | sdsl } id pvc { id | tag } enable
interface adsl id pvc { id | tag } qos { ubr | cbr | vbr }
show interface adsl id pvc { id | tag } qos
interface { adsl | sdsl } id pvc { id | tag } vpi vpi-val
show interface { adsl | sdsl } id pvc { id | tag } vpi
interface { adsl | sdsl } id pvc { id | tag } vci vci-val
show interface { adsl | sdsl } id pvc { id | tag } vci
interface { adsl | sdsl } id pvc { id | tag } cp { profile-id | profile-tag | default }
show interface { adsl | sdsl } id pvc { id | tag } cp