Netopia CLI 874 - Manual (Page 50)

2-38 Command Line Interface Commands Reference
mapping rules.
■ iptos-promote - allows you to enable or disable the translation of 802.1p priority bits to and from the
IP-TOS header bit field. When enabled, write any 802.1p priority bits into the IP-TOS header bit field for
received IP packets on this por t destined for this VLAN; and write any IP-TOS priority bits into the 802.1p
priority bit field for tagged IP packets transmitted from this por t for this VLAN. All mappings between
Ethernet 802.1p and IP-TOS are made according to a pre-defined QoS mapping policy.
■ authprofile - allows you to associate this VLAN with an 802.1x authentication profile specified by name or
id.
■ inter-vlan-routing - (suppor ted beginning with Firmware Version 8.7.4) when set to yes, allows you to
associate this VLAN with an inter-VLAN routing group such that the specified VLAN can communicate with
another VLAN in the same group. VLANS that are not associated with the same inter-VLAN routing group
cannot communicate with each other.
vlan id interface ssid n tag { yes | no }
no vlan id interface ssid n
These commands allow you to create or delete a por t-based VLAN specified by id on a wireless SSID, if
available, indicated by its SSID number.
vlan id interface usb 0 tag { yes | no }
no vlan id interface usb 0
These commands allow you to create or delete a por t-based VLAN specified by id on the Router’s USB por t, if
available.
vlan id interface cp n tag { yes | no }
no vlan id interface cp n
These commands allow you to create or delete a por t-based VLAN specified by id on the Router’s console por t,
if available, indicated by its por t number n.
show config vlan { id }
This command allows you to display the configuration of all VLANs or a par ticular VLAN specified by id.