Netopia CLI 874 - Manual (Page 157)

Motorola Netopia® Router Connection Profile Commands 3-13
show cp { name | index } ip dhcp client [ renew | release ]
Note: This command is suppor ted beginning with firmware version 8.5.
This command allows you to renew or release the ethernet WAN IP address lease being ser ved via DHCP for the
specified connection profile.
cp { name | index } ip mask local ip-mask
This command allows you to set the profile’s local WAN IP mask.
cp { name | index } ip mask remote ip-mask
This command allows you to set the profile’s remote WAN IP mask.
cp { name | index } ip multicast-fwd { yes | no }
no cp { name | index } ip multicast-fwd
show cp { name | index } ip multicast-fwd
These commands allow you to set, show, or disable multicast for warding on the specified connection profile.
cp { name | index } ip negotiate-lan { yes | no }
no cp { name | index } ip negotiate-lan
show cp { name | index } ip negotiate-lan
These commands allow you to set, delete, or show whether the specified connection profile will attempt to
negotiate the router hub’s IP address and subnet mask from the central site router.
The firmware includes PPP suppor t for the IPCP Subnet Mask option documented in PPP Internet Protocol
Control Protocol Extensions for IP Subnet, draft-helenius-ppp-subnet-00.txt. This option, together with the IPCP
IP Address option, allows a central site router to supply an entire IP subnet, rather than a single IP address, for
use by a CPE router.
PPP Ethernet LAN reconfiguration is controlled by an ip negotiate-lan connection profile flag. If the applicable
connection profile specifies an unnumbered, non-NAT connection and the ip negotiate-lan flag is yes, PPP will
attempt to negotiate both an IP Address and subnet mask.
IP Gateway DHCP ser ver
DNS ser ver 1 DNS ser ver 2 (if any)
Lease Expiration