Netopia CLI 874 - Manual (Page 47)

Motorola Netopia® Router CLI Commands 2-35
interface ethernet id ip vrrp vrouter id preempt-mode enable [ no | yes | on | off ]
show interface ethernet id ip vrrp vrouter id preempt-mode enable
These commands allow you to enable, disable, or display the status of preempt mode. The default is enabled.
interface ethernet id ip vrrp vrouter id enable [ no | yes | on | off ]
show interface ethernet id ip vrrp vrouter id enable
These commands allow you to enable, disable, or display the status of the Vir tual Router.
no interface ethernet id ip vrrp vrouter id
This command allows you to delete a Vir tual Router.
show interface ethernet id ip vrrp wan-monitor enable [ { yes | no | on | off } ]
show interface ethernet id ip vrrp wan-monitor enable
These commands allow you to enable, disable, or display the status of the WAN monitor.
interface ethernet id ip vrrp master-dhcp-srv enable [ { yes | no | on | off } ]
show interface ethernet id ip vrrp master-dhcp-srv enable
These commands allow you to enable, disable, or display the status of the DHCP behavior. The Vir tual Router
can either ser ve or relay DHCP only if it is in Master state.
interface ethernet id ip vrrp dhcp-gateway ip-addr
show interface ethernet id ip vrrp dhcp-gateway
These commands allow you to specify or display the Vir tual Router DHCP gateway IP address.