Frame relay configuration commands, Frame relay configuration commands -101 – Netopia CLI 874 User Manual

Page 113

Motorola Netopia® Router CLI Commands 2-101

When the DHCP client is activated on a RFC1483 MER inter face, it examines the dhcp client mode in the
associated connection profile (or the default profile there was no explicitly configured connection profile). If the
dhcp client mode specifies standard, the DHCP client initializes the htype and hlen fields in the header of its
DHCP requests to the appropriate values for an RFC1483 MER inter face (htype = 1 and hlen = 6). If the dhcp
client mode specifies copper-mountain or cmn, the DHCP client initializes the htype and hlen fields in the
header of its DHCP requests to zero.

When the DHCP client is activated on an Ethernet WAN inter face, it examines the dhcp client mode in the
associated IP configuration structure, and behaves as described above for the RFC1483 MER DHCP client.

Note:

cmn is accepted as a synonym for copper-mountain.

Both of these commands are suppor ted only on hardware that has a copper mountain SDSL, IDSL, or Ethernet
WAN inter face!

Frame Relay Configuration Commands

frame-relay dlci number [ tag tag ] [ ip-addr { 0.0.0.0 | remote-ip-addr } ]
[ cir { default | 1-accessrate }] [ bc { default | 1-accessrate }] [ be { default | 0-accessrate }]
[ {disable | enable} ]

This command allows you to manually configure a DLCI. If the IP address is 0.0.0.0 the router will attempt to
auto-discover the remote IP address. The router supplies a default DLCI 16 with a 0.0.0.0 address, so in many
cases manually configuring a DLCI is unnecessar y.

Examples:

To add a DLCI using all of the default values, type:

frame-relay dlci 17

Frame Relay Configuration Commands

frame-relay lmi type { none | annexa | annexd | ansi | ccitt | lmi }
no frame-relay lmi type
show frame-relay lmi type

frame-relay tim { none | standard | buffered }

show frame-relay lmi statistics

show frame-relay pvc