beautypg.com

Netopia CLI 874 User Manual

Page 58

background image

2-46 Command Line Interface Commands Reference

interface isdn id line type { switched | leased | idsl-ascend | idsl-cmn }
show interface isdn id line type

These commands allow you set or show the ISDN inter face mode: switched, leased, idsl-ascend (IDSL for
Lucent/Ascend Communications central office equipment), or idsl-cmn (IDSL for Copper Mountain Networks
central office equipment).

Example:

interface isdn 1 mode leased

show interface isdn id status [ b1 | b2 ]

This command allows you display the status of the specified ISDN/IDSL inter face. For a switched ISDN
inter face, you may specify the optional keyword b1 or b2, in which case the status of the specified B-channel is
displayed rather than the status of the inter face itself.

For a leased ISDN/IDSL inter face, the possible status strings and their meanings are:

For a switched ISDN inter face, the possible status strings and their meanings are:

Status String

Meaning

Inactive

The inter face is not yet active.

Waiting for rate negotiation

The inter face is in the process of sensing the data rate
configured for the IDSL line at the central office. This status
applies only to an inter face set to idsl-cmn mode, in which the
router can sense the data rate automatically.

Backup recover y in progress

The inter face is in the process of recovering back to the
primar y inter face from a backup inter face after a failure.

Connected at xxx Kbps

The inter face is connected to the DSLAM or other end device at
the specified data rate. (xxx will be one of 64, 128, or 144.)

Status String

Meaning

Inactive

The inter face is not yet active.

Active

The inter face is active, and this is an inter face that does not
require SPIDs.

Active, n of m SPIDs
registered

The inter face is active, and this is an inter face that requires
SPIDs. n indicates the number of SPIDs that have been
successfully registered so far, and m indicates the total
number of SPIDs to be registered. If n is less than m, the
device is still in the process of registering some of the SPIDs.