beautypg.com

Restricted wan interface configuration commands – Netopia CLI 874 User Manual

Page 56

background image

2-44 Command Line Interface Commands Reference

show interface intf-type id statistics
show interface intf-type id stats

These commands allow you to display statistics for the specified inter face, including receive frames, octets,
and errors, and transmit frames, octets, and errors. For switched ISDN inter faces, the statistics are broken
down by channel.

show interface wan id status

Note:

This command is suppor ted beginning with firmware version 8.5.

This command allows you to view the general status of the WAN. It displays:

Inter face type

MAC address

IP Address

Status (Down, Activating, or Connected)

interface wan 0 tracking { yes | no }

For D-Series CSU/DSU equipment, this command allows you to track or not track the primar y inter face speed.
Specifying yes means the primar y inter face (AUX) speed will be tracked, which is the default. Changing this to
no currently means that we will be running at 1.5 MHz.

Restricted WAN Interface configuration commands

interface { adsl | ethernet | isdn | sdsl } id pppoe enable { yes | no }
no interface { adsl | ethernet | isdn | sdsl } id pppoe enable
show interface { adsl | ethernet | isdn | sdsl } id pppoe enable

These commands allow you enable, disable, or show the PPP over Ethernet behavior of the specified inter face.

interface { adsl | sdsl } id pvc { id | tag } { yes | no }

This command allows you to enable or disable a Permanent Vir tual Circuit (PVC) on the specified ADSL or SDSL
inter face.

interface { adsl | sdsl } id pvc { id | tag } pcr num
show interface { adsl | sdsl } id pvc { id | tag } pcr

These commands allow you to assign or show a Peak Cell Rate value (PCR) on a specified Permanent Vir tual
Circuit (PVC) on an ADSL or SDSL inter face.

Motorola Netopia

®

routers suppor t two ATM classes of ser vice for data connections: Unspecified Bit Rate (UBR)

and Constant Bit Rate (CBR). You can configure these classes of ser vice on a per VC basis. The default ATM
class of ser vice is UBR for data. The ATM class of ser vice is not configurable for voice vir tual circuits.