Netopia CLI 874 - Manual (Page 160)

3-16 Command Line Interface Commands Reference
cp { name | index } telco dn [ 1 | 2 ] string
This command allows you to set the profile’s director y number, or number-to-dial (DN). The number can be up to
32 characters in length and may contain non-dialable characters, which are ignored when placing a call.
Note: For the cp and no cp versions of this command, if no DN index is specified, 1 is assumed. For the show
cp version of this command, if no DN index is specified, both DNs will be displayed, each on its own line.
cp { name | index } telco prefix string
This command allows you to set the profile’s dial prefix. The prefix can be up to three characters long and may
contain non-dialable characters, which are ignored when placing a call. The prefix field is prepended to the
director y number when placing a call.
Note: This parameter is used ONLY by routers with analog modem inter faces installed.
cp { name | index } telco callback { yes | no }
This command allows you to configure a profile so that when it is used to accept an incoming call, the router will
hang up that call and use its (prefix and) director y number to call back the device that originated the initial call.
This is useful when you want a par ticular par ty to be billed for WAN connections.
cp { name | index } ip nat enable { yes | no }
This command allows you to enable or disable Network Address Translation for the profile. Enabling NAT is not
sufficient – you must also attach a rule list and optionally a ser ver list using the commands below.
cp { name | index } ip nat rule-list list-tag
This command allows you to attach a previously configured IP NAT rule list to a par ticular profile. list-tag should
be the name of the desired rule list to use for this profile.
no cp { name | index } ip nat rule-list
This command allows you to detach an IP NAT rule list from a par ticular profile.
cp { name | index } ip nat server-list list-tag
This command allows you to attach a previously configured IP NAT ser ver list to a par ticular profile. list-tag
should be the name of the desired ser ver list to use for this profile.
no cp { name | index } ip nat server-list
This command allows you to detach an IP NAT Ser ver List from a par ticular profile.
show cp { name | index } id
This command displays a connection profile’s name and index number. name can be any unique descriptive
alphanumeric string. index can be any value from 1 to 16.