Netopia CLI 874 - Manual (Page 7)

Introduction 1-1
Chapter 1
Introduction
This Command Line Inter face Commands Reference contains information on the syntax and use of the
Command Line Inter face for the Motorola Netopia
®
router family. It provides information required to configure
the router firmware and troubleshoot problems using the Command Line Inter face.
This document is intended for small office, home office, and remote office users, and other networking
professionals who administer networks using Motorola Netopia
®
routers.
Note: Restrictions among firmware versions are noted in the body of this document. Where no firmware
version is noted, the commands given are suppor ted on all platforms.
New Commands in Firmware Version 8.7.4
Firmware Version 8.7.4 adds new and revised commands for the following:
■ IP multicast to layer 2 unicast mapping. See “IGMP Configuration Commands” on page 2-70.
■ Change backup timer from minutes to seconds. See “Backup Configuration Commands” on page 2-115 .
■ Suppor t for router-generated packets with source address outside of local member range for IPSec force all
tunnels. See
“Unprotected Ser vices Configuration Commands” on page 2-68 .
■ Enhanced VLAN Suppor t and configuration changes. See “Vir tual LAN (VLAN) configuration commands” on
page 2-36 .
■ DHCP Filterset, Option Groups, DHCP Generic Options suppor t. See “DHCP Gen-Options, Option Groups,
and Option Filtersets Commands” on page 2-77 .