Netopia CLI 874 User Manual
Page 129

Motorola Netopia® Router CLI Commands 2-117
backup failure layer-2 delay 0..65535
no backup failure layer-2 delay
show backup failure layer-2 delay
Note:
Beginning with Firmware Version 8.3.3, these commands are unncessar y and consequently no longer
suppor ted.
These commands allow you to specify, disable, or show the layer-2 backup failure delay inter val. Note that l2 is
an acceptable synonym for layer-2.
backup recovery rip tx disable [ yes | no ]
no backup recovery rip tx disable
show backup recovery rip tx disable
Note:
These commands are suppor ted beginning with Firmware Version 8.6.1.
These commands allow you to disable, enable, or show the status of RIP ser vices on the primar y WAN inter face
when the Router is in Backup mode. RIP ser vices ordinarily will continue to run on the primar y inter face when in
Backup mode, attempting to determine “layer 2” connectivity.
Usually, the no setting is desirable, since it may be required to ping the configured host that determines “layer
2” connectivity. However, RIP running on the recovering primar y inter face may cause problems specific to your
application. When in Backup mode, RIP routes are still sent and received through the primar y inter face, even
though that is not the active inter face.