Netopia CLI 874 User Manual
Page 41
Motorola Netopia® Router CLI Commands 2-29
interface ethernet id ip filterset fs-id
no interface ethernet id ip filterset
show interface ethernet id ip filterset
These commands allow you to enable, disable, or show an IP filterset identified by fs-id on the specified
Ethernet inter face. fs-id is specified as an ASCII string corresponding to the name of a filterset. See
Configuration Commands” on page 2-121
for more information.
interface ethernet id ip nat enable { yes | no }
no interface ethernet id ip nat enable
show interface ethernet id ip nat enable
These commands allow you to enable, disable, or show the Network Address Translation behavior for the
specified WAN inter face.
interface ethernet id ip nat map-list list-tag
no interface ethernet id ip nat map-list
show interface ethernet id ip nat map-list
These commands allow you to set, delete, or show a NAT map list for the specified WAN inter face.
interface ethernet wan-id ip nat passthrough enable { yes | no }
no interface ethernet id ip nat passthrough enable
show interface ethernet id ip nat passthrough enable
Note:
These commands are suppor ted beginning with firmware version 8.2.
These commands allow you to enable, disable, or show the NAT passthrough behavior for the specified WAN
inter face. The IP passthrough feature allows for a single LAN PC to have the router’s public address assigned to
it, in addition to providing PAT (NAPT) via the same public IP address for all other hosts on the private LAN
subnet.
interface ethernet wan-id ip nat passthrough dhcp enable { yes | no }
no interface ethernet wan-id ip nat passthrough dhcp enable
show interface ethernet wan-id ip nat passthrough dhcp enable
Note:
These commands are suppor ted beginning with firmware version 8.2.
These commands allow you to enable, disable, or show the NAT passthrough DHCP behavior for the specified
WAN inter face. This governs DHCP addressing for the passthrough host.
interface ethernet wan-id ip nat passthrough dhcp mac-address { mac-address }
show interface ethernet wan-id ip nat passthrough dhcp mac-address
Note:
These commands are suppor ted beginning with firmware version 8.2.
These commands allow you to set or show the NAT passthrough DHCP MAC address for the specified WAN
inter face. This specifies the MAC address of the passthrough host.