Netopia CLI 874 - Manual (Page 66)

2-54 Command Line Interface Commands Reference
Note that setting the mode value to generic will not change any other WAN inter face module parameter; thus,
the following command:
interface sdsl 1 operation mode generic default
will be rejected as a syntax error.
interface sdsl id pvc vpi-value vci-value
show interface sdsl id pvc
These commands allow you to set, change, or show the PVC VPI and VCI values associated with the SDSL WAN
inter face.
interface sdsl id region { annexa | annexb }
show interface sdsl id region
These commands allow you to specify or show the region setting for devices that suppor t multiple (Nor th Amer-
ican/non-Nor th American) regions.
Note: These commands apply only to cell-based SDSL (R7200) inter faces.
interface { sdsl | isdn } id rfc1973 dlci { 16 .. 991 }
show interface { sdsl | isdn } id rfc1973 dlci
These commands allow you to set or show an RFC 1973 DLCI for the SDSL or ISDN WAN inter face.
Note that the only WAN inter face modules that currently suppor t RFC 1973 are the U/ISDN (31xx) and Copper
Mountain SDSL (71xx). Attempts to set or show RFC 1973 parameters on any other WAN inter face module will
return an error.
interface { sdsl | isdn } id rfc1973 enable { yes | no }
no interface { sdsl | isdn } id rfc1973 enable
show interface { sdsl | isdn } id rfc1973 enable
These commands allow you to enable, disable, or show RFC 1973 (PPP) behavior on the SDSL or ISDN WAN
inter face.
interface { sdsl | isdn } id rfc1973 lmi { none | lmi | ccitt | ansi | annexa | annexd }
no interface { sdsl | isdn } id rfc1973 lmi
show interface { sdsl | isdn } id rfc1973 lmi
These commands allow you to specify, disable, or show the RFC 1973 (PPP) Local Management Inter face (LMI)
type on the SDSL or ISDN WAN inter face.
The keywords ccitt and annexa are synonyms, as are the keywords ansi and annexd.