HP B1000 - Manual (Page 149)

Chapter 4 149
Field Replaceable Units
FRU Removal and Replacement
Figure 4-62. Installing the System Board
2. Re-attach the cables described in step 7 of “Removing the System Board” on page 147
and replace the two T-15 Torx screws on the rear of the chassis.
3. Replace the following components:
a. Power supply
b. DIMM cards
c. Hard disk drive fan
d. PCI air divider
e. PCI cards
f. PCI retainer
4. Replace the left side panel as explained in the section “Opening the Left Side Panel of
the System Unit” in this chapter.
Fan
Power
Fan
Power
LCD Display
Connector
Connector
Fan Power
Connector
Speaker
CD Drive
Connector
Floppy
Drive
Connector
Ultra2 Wide LVD SCSI Connector
Connector
CD Power
Connector
Connector