HP B1000 - Manual (Page 113)

Chapter 4 113
Field Replaceable Units
FRU Removal and Replacement
Figure 4-18. Removing CPU Area Fans
Note that you can replace the fans using the original rivets; however, the plastic rivets will
be slightly deformed. If you would like new rivets to replace the old ones, new rivets for
mounting the fans are supplied in the replacement kit.
Installing the Fans for the CPU Area
To replace the system board fans, do the following:
Installing the Bottom Fan
1. Position the bottom fan so its power cable channel is against the system unit chassis,
and the power cable channel as you face the fan is in the lower right corner.
2. Slide the lower left corner of the fan into the fan support. See Figure 4-15.
3. Line up the rivet holes of the fan with the rivet holes of the system unit chassis.
4. Press the plastic rivets into place. See Figure 4-17.
5. Plug the fan power cable into its connector on the system board. See Figure 4-18.
Installing the Top Fan
1. Position the top fan so its power cable channel is up against the workstation chassis,
and the power cable channel as you face the fan is in the upper right corner.
2. Line up the rivet holes of the fan with the rivet holes of the system unit chassis.
3. Press the plastic rivets into place. See Figure 4-17.
4. Plug the fan power cable into its connector on the system board. See Figure 4-18.
(Upper)
System Fan 2
(Lower)
System Fan 3
Top of
Workstation
Front of
Workstatio