HP B1000 - Manual (Page 108)

108 Chapter 4
Field Replaceable Units
FRU Removal and Replacement
Installing I/O Cards
To install a new I/O card, do the following:
NOTE Slots two and four are the graphics card slots. The primary graphics card slot
is slot number two and the secondary graphics card slot is slot number four.
1. Open the left side panel of the system unit as explained in the section “Opening the Left
Side Panel of the System Unit” in this chapter.
2. Locate the appropriate slot for the I/O card that is to be installed. See Figure 4-12.
3. Unscrew the T-15 Torx screw from the bulkhead blank of the slot you have chosen. If no
blank is present, you may skip to step four.
4. Pull evenly in the direction of the arrow on both sides of the I/O card retainer to remove
it. See Figure 4-13.
5. Insert the I/O card into the slot you have chosen with the bulkhead appropriately
positioned. The ends of the card should be placed in the I/O card guides. Press firmly
and evenly on the I/O card until it is in the connector. Screw the T-15 Torx screw into
the I/O card’s bulkhead to secure the I/O card.
6. Replace the I/O card retainer by placing the bottom retainer clip in the slot on the air
divider and the clips on the PULL tabs snap into their slots on the upper chassis.
7. Close the left side panel of the system unit by following the procedure in the section
“Closing the Left Side Panel of the System Unit” in this chapter.