HP R4.2 - Manual (Page 467)

A
Summary of Commands diagnose card
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 428
• -i — Enables secondary command registration. See the description of -i
for LSPS/SSP cards below.
For LSPS/SSP cards, the valid options are:
• -n — Disables prompting from the system whether to wait until a conflict
has been resolved (see the -i option) or to terminate the request to
diagnose.
• -i — Enables secondary command registration. If T1 diagnostics are
being run, this option allows another card to be diagnosed. If -i is used
and another maintenance command is being run (remove , detach ,
attach , restore), the request to diagnose a non-T1 card is blocked and a
message is printed to the screen. If -i is not used and any maintenance
command is being run, the request to diagnose card is blocked and a
message is printed to the screen.
If the command is permitted to run, a check is made to see if the
command is in conflict with another. A command is in conflict if the card or
card associated with it:
~ Is the T1 card being diagnosed
~ Has an interdependency with the T1 card being diagnosed (for
example, PRI)
If one of the above conflicts exist and -n is not used, the user is asked
whether to wait until the conflict is resolved or to terminate the request. If
T1 diagnostics are executing online tests and a conflict is detected, the
diagnose card
command is blocked. If T1 diagnostics are executing