HP R4.2 - Manual (Page 296)

6
Peripheral Administration Modem Administration
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 257
Configuring the
Modem Using the
Modem Control
Panel The 3820 and 3920 Plus modems have a Diagnostic Control Panel (DCP)
that is the user interface to the modem. Use the procedures below to
configure the 3820 modem via its control panel:
Activate the Unix Dial Default Factory Configuration
To activate the UNIX Dial default factory setting:
1 Turn the modem off and then back on.
2 Press or on the modem to display Configure .
3 Press the function key under Configure ( F 1 or F 2 ).
Modem response:
Ld EditArea frm.
4 Press or to display Factory .
5 Press F 1 to display the factory preset configuration.
Modem response:
LD Fact Preset:
6 Press or to display Unix Dial .