HP R4.2 User Manual

Page 194

Switch Interface Administration

Digital Interfaces

UCS 1000 R4.2 Administration 585-313-507

Issue 3 April 2000 155

Enter the type of addressing to be used with outgoing calls, either DTMF,
MF, or DECADIC in the

Outgoing Addressing Type:

field. The default

is DTMF.

Enter the type of addressing to be used with incoming calls, either DTMF,
MF, or DECADIC in the

Incoming Addressing Type:

field. The default

is DTMF.

Enter the type of signaling to be used with outgoing calls, either Wink or
Immediate in the

Outgoing Signaling Type:

field. The default is

Wink.

Enter the type of signaling to be used with incoming calls, either Wink or
Immediate in the

Incoming Signaling Type:

field. The default is

Wink.

Enter the volume adjustment for all incoming speech on circuit cards in
the

Incoming Speech Volume:

field. Valid values are 0 to 32000. Note

that values less than 100 or greater than 8000 may distort the incoming
speech. The default is 1414.

Any adjustment occurs before the system processes the incoming speech
for coding it later for playback. The value in the

Incoming Speech

Volume:

field represents a gain applied to the speech input using a

logarithmic scale. A value of 1000 equals no gain; that is, the input is
coded at the same level as it is received. Multiplying by 1.414 (the square
root of 2) approximately doubles the input volume, or increases it by 3 dB.
Therefore, a value of 1414 in the field doubles the volume of incoming