HP R4.2 - Manual (Page 456)

A
Summary of Commands delete card/channel
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 417
Synopsis
delete card from [eqpgrp]
delete channel from [eqpgrp]
Description
The delete card/channel command removes the specified card or channel
from a service or equipment group. The parameters for the delete
card/channel command are:
• — Specifies the card or channel number (a single card or
channel number from a range of 0–255, a range of card or channel
numbers in the form m–n, or the word all for all card or channel numbers).
• eqpgrp — Specifies “svcgrp” when deleting from a service group or
“eqpgrp” when deleting from an equipment group. If no group type is
given, the “svcgrp” is assumed.
• — Identifies the equipment group or service group.
If you want to remove all cards or channels from an equipment group, it may
be easier to delete the entire equipment group than to delete channels or
cards. To delete an equipment group, use the delete eqpgrp command.