HP R4.2 - Manual (Page 454)

A
Summary of Commands defService
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 415
When the application is started by the Application Dispatch (AD) process, the
IRP_SERVICE_NAME is set to the
-s argument if
is non-NULL. Otherwise , IRP_SERVICE_NAME is set to
, where the default is NULL.
The -t option specifies whether the process that provides the IRAPI
application is a permanent (P) or transient (T) process. The
default is P for permanent.
If the process that provides the IRAPI application is a
permanent process, then -p must be the name the process uses
as an argument to irRegister(3irAPI). If the process that provides the IRAPI
application is a transient process, then -p must be
the full pathname of the process. No default exists for this option.
When the application is executed on a PRI line, the [-a 0 |1 |2 |3 |4] option
specifies how the ANI should be supplied to the application. The valid values
for this option are as follows:
• 0 — No ANI supplied; the default
• 1 — ANI type billing number only
• 2 — ANI type billing number preferred
• 3 — ANI type calling party SID)) only
• 4 — ANI type calling party (SID) preferred