HP R4.2 - Manual (Page 463)

A
Summary of Commands detach
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 424
• -n — This optional parameter disables prompting from the system
whether to wait until a conflict has been resolved (see the -i option below)
or to terminate the request to detach.
• -i — This optional parameter is used to enable secondary command
registration. If T1 diagnostics are being run, this option allows the
“detaching” of another card. If
-i is used and another maintenance
command is being run ( remove , detach , attach , restore , diagnose), the
request to detach is blocked and a message is printed to the screen. If -i
is not used and any maintenance command is being run, the request to
detach is blocked and a message is printed to the screen.
If the command is permitted to run, a check is made to see if the
command is in conflict with another. A command is in conflict if the card or
card associated with it:
~ Is the T1 card being diagnosed
~ Will cause a change in the existing TDM bus master assignment
~ Has an interdependency with the T1 card being diagnosed (for
example, PRI)
If one of the above conflicts exist and -n is not used, the user is asked
whether to wait until the conflict is resolved or to terminate the request. If
T1 diagnostics are executing online tests and a conflict is detected, the
detach
command is blocked. If T1 diagnostics are executing offline tests
and a conflict is detected, the user is asked whether to wait until the
conflict is resolved or to terminate the request to detach.