HP R4.2 - Manual (Page 198)

4
Switch Interface Administration Digital Interfaces
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 159
The Card Number: field is blank in Figure 90 on page 158 . After you enter
the circuit card number, certain E1-only fields disappear ( Idle Code: , A-
LAW or MU-LAW: , and CRC: ).
3 Change any of the parameters as described in Assigning T1 A/B Robbed-
bit E&M to Digital Circuit Cards on page 151 .
4 Press F 3 (Save).
The system changes the protocol parameters on the selected circuit card.
Displaying T1 A/B
Robbed-bit E&M
Parameters The circuit card must first be assigned to the T1 A/B Robbed-bit E&M
protocol to use this procedure. See
Assigning T1 A/B Robbed-bit E&M to
Digital Circuit Cards on page 151 for more information about making the
initial assignment.
To display the T1 A/B Robbed-bit E&M parameters:
1 Start at the T1 A/B Robbed-bit E&M menu ( Figure 88 on page 151 ) and
select:
> Display Parameters