HP R4.2 - Manual (Page 303)

6
Peripheral Administration Modem Administration
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 264
Configuring the
Modem Using a
Terminal To configure the modem terminal:
1 Connect a terminal to the 3820 modem.
Note: See the documentation provided with the terminal for connection
instructions.
2 Verify that the terminal is acting as a DTE.
3 Set the terminal line to 8 bits, no parity, and 1 stop bit.
4 Set the baud of the terminal line to the required modem speed.
5 Enter AT from the terminal.
Modem response:
OK
Note: If the modem does not display OK , the modem is unable to accept
AT commands from the terminal. Check the connection and the
terminal setup.
6 Enter
AT&F3L0&D2&S1\N0\Q3S41=dial line rateS2=128&W0
where dial line rate is one of the following bauds:
~ 3 = 9600
~ 5 = 4800