HP R4.2 - Manual (Page 421)

A
Summary of Commands attach
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 382
attach
The attach command attaches a unit (card).
Synopsis
attach unit number [-i] [-n]
Description
The attach command is used to attach a card that has been “detached.” Use
the attach command to allow the voice system to use a card that has just
been replaced by hot swapping (that is, like-for-like replacement).
To put the card into service, use the restore command.
The parameters for the attach command are:
• unit — This option identifies the unit; the choices are “channel” or “card.”
• number — This option specifies the channel or card number, a range of
channel or card numbers in the form m–n, or all for all channel or card
numbers. Card numbers are in the form
card#[.port#] where port# is a
port of the card # . If port# is not given, all ports of the card specified are
attached. If no card number or channel number is given, the system
displays a syntax message.