HP R4.2 - Manual (Page 150)

3
Voice System Administration Voice Equipment
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 111
3 Enter the equipment group or groups to which you want to assign the
channels in the
Groups: field. Type a single equipment group number, or
a range of equipment group numbers separated by commas or spaces.
Valid equipment group numbers are 0 to 30.
Note: Equipment group 31 is a reserved group. It is used to specify
channels that the system should ignore when it executes a soft
seizure (soft_szr command). This allows you to mark certain
channels as not being in the channel group specified by a soft
seizure request on “any channel, any equipment group.” If a
channel is assigned to equipment groups 0 and 31, it is only
considered for soft seizures that specifically request equipment
group 0.
4 Press F 3 (Save).
The system assigns the specified channels to the selected equipment
groups.