Avago Technologies 3ware 9650SE-12ML (Channel) - Manual (Page 40)

First-Time RAID Configuration Using 3BM
28 3ware SAS/SATA RAID Software User Guide, Version 9.5.1
Figure 15. Summary of Volumes to be Created
To finish up and save your changes
1 If you have additional drives, you can go ahead and configure an
additional RAID unit or designate a hot spare. Then continue on with
these steps. (For details about hot spares, see page 30.)
2 If you configured more than one unit, and you plan to install the operating
system on one of them, make that unit be the first unit (Unit 0) in the list
of Exportable Units.
To move a unit up in the list, highlight it and press the Page Up key.
You will also want to make sure that the controller is the boot device for
your computer. After finalizing the configuration below, be sure to follow
the steps under “Checking the Motherboard Boot Sequence” on page 31.
3 When you are finished configuring units, press F8 to save the changes
and exit 3BM.
A warning message asks you to confirm that all existing data on the drives
will be deleted.
Figure 16. Confirmation Message when Saving and Exiting