Avago Technologies 3ware 9650SE-12ML (Channel) - Manual (Page 139)

Setting Unit Policies
www.3ware.com 127
• Units with Rapid RAID Recovery enabled will not be readable if moved
to controllers using pre-9.5.1 firmware. If you wish to move the unit to a
controller with pre-9.5.1 firmware, you must first disable Rapid RAID
Recovery.
• Units created on controllers with pre-9.5.1 firmware will not be able to
take advantage of Rapid RAID Recovery when the controller is updated
to 9.5.1 or later. These units will show Rapid RAID Recovery as disabled.
Changing or disabling Rapid RAID Recovery
Rapid RAID Recovery can only be enabled (that is - set to All or Rebuild)
when the unit is created. You can change between All and Rebuild at any
time. However, if you disable Rapid RAID Recovery, you cannot then enable
it.
To change or disable Rapid RAID Recovery for an existing unit
through 3DM
1 Choose Management > Controller Settings from the menu bar in 3DM.
2 In the Unit Policies section of the Controller Settings page, select All ,
Rebuild, or Disable from the Rapid RAID Recovery dropdown menu.
3 Click OK when 3DM asks you to confirm your selection.
The page refreshes, and a message at the top confirms the change that you
have made.
To change or disable Rapid RAID Recovery for an existing unit
through 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
Enter .
An asterisk appears in the left-most column to indicate that it is selected.
2 Tab to the Maintain Unit button and press Enter .
3 On the pop-up menu, select Configure and press Enter .
4 In the Configure Disk Array screen, Tab to the field Rapid RAID
Recovery and select Fast Rebuild/Shutdown , Rebuild, or Disable .
A warning message appears, asking you to confirm your selection.
5 Type ‘Y’.
6 Make any other unit configuration changes you wish to implement and
press
Enter .