Using snooze, Setvga egac, Snooze – Epson Equity 286 PLUS User Manual
Page 90: Snooze 15, Snooze 0
Use one of the following values for emulation:
For example, type the following and press
Enter:
SETVGA EGAC
Using SNOOZE
The SNOOZE utility causes your monitor screen to go blank
after a specified period of time if your system has been inactive.
This prevents any single image from being “burned into” the
monitor screen. The screen remains blank until you press any
key; then it resumes display of the current activities.
To activate the utility, type
SNOOZE
and press
Enter. You
see
information about the SNOOZE command syntax and a
message that the SNOOZE delay is set to 5 minutes.
The default period of inactivity before the screen goes blank is
5 minutes. You can specify your own time period by entering a
number from 1 to 60 (minutes) on the SNOOZE command line.
For example, to set a SNOOZE delay of 15 minutes, type the
following and press
Enter:
SNOOZE 15
To disable SNOOZE, type
SNOOZE 0
and press
Enter.
4-18
Enhancing System Operations