Adding memory modules – Epson Equity 286 PLUS User Manual
Page 112
7.
Lift the entire subassembly out of the computer and carefully
place it on your work surface.
Adding Memory Modules
Your computer comes with
1MB
of memory which is soldered
directly onto the main system board. By installing SIMMs
(single inline memory modules), you can increase the amount of
memory in your computer up to 5MB. (You can add a memory
card, however, if you want to expand your computer’s memory
up to 16MB.)
Caution
It is best to have your dealer install memory modules for you
because they can be damaged easily if installed incorrectly.
If you prefer, you can install them yourself by carefully
following the instructions in this section. However, you could
transmit an electrostatic discharge and damage your
components; so read this entire section before you begin.
Before you install SIMMs, check the following guidelines to
ensure that they will work properly:
Use SIMMs that operate at 100ns (nanosecond) or faster
access speed. Be sure all the SIMMs operate at the same
speed.
Use the correct SIMM configuration to add the amount of
memory you want. See the table on the next page.
Once you have the SIMMs you need, you or your dealer can
install them in your computer. If you are going to install them
yourself, follow the instructions in this section.
5-22
Installing and Removing Options