Setting the hard disk drive jumpers, Setting the jumpers for two hard disk drives – Epson Equity 286 PLUS User Manual
Page 143
Setting the Hard Disk Drive Jumpers
You need to check or change the hard disk drive jumper settings
if you are installing or removing any hard disk drives. The
jumpers tell the computer whether you are using one hard disk
drive or two.
Note
You do not need to set these jumpers if you are removing your
only hard disk drive.
If you remove one hard disk drive and leave another in your
computer, you need to change the jumper settings on the
remaining drive to indicate that you now have only one hard
disk drive installed.
If you are installing your first hard disk drive and it is the only
one you are going to install, see “Changing the Jumper Settings”
on the next page to check the jumpers on your drive.
If you’ll be using two hard disk drives, see “Setting the Jumpers
for Two Hard Disk Drives,” below.
Setting the Jumpers for Two Hard Disk Drives
If you install two hard disk drives in your system, you must
change the jumper settings on each drive to indicate which
drive is the “master” drive and which is the “slave” drive.
A master drive is the drive on which you’ll install the operating
system that the computer loads into its memory each time you
turn it on. You can run application programs and store data on
both the master drive and the slave drive, but the operating
system must be contained on the master drive.
Follow the instructions in the next section to change the jumper
settings on both of your hard disk drives.
B-4
Installing and Removing Disk Dives