Wschange – Epson Equity 286 PLUS User Manual
Page 86
For example, if you want your screen to display 132 columns and
25 rows, type the following and press
Enter:
VGAMODE 132, 25
To use VGAMODE, you must configure the application
program that uses VGAMODE for the same screen sire. See the
appropriate section below for your application program(s).
Note
Certain monitors cannot display 132 columns or 50 rows on
the screen. The following table specifies the number of rows
that can be displayed on common monitors:
Running WordStar, versions 4.0 and
5.0
After you install WordStar version 4.0 or 5.0 on your hard disk,
follow these steps:
1.
Install the VGAMODE utility, if you have not already done
SO.
2.
Log onto your WordStar directory.
3.
Type the following and press
Enter
to start WordStar’s
installation program:
WSCHANGE
4.
The program asks for the name of your WordStar program
file. If you installed WordStar without changing the
program filename, this file is named WS.EXE. Type the
filename and press
Enter.
4-14
Enhancing
System Operations