Epson Equity 286 PLUS - Manual (Page 157)

Connecting the Hard Disk Drive Cables
Follow these steps to lift up the subassembly and connect the
drive cable to the main system board:
1. Remove the front panel from the computer by lifting up
slightly on the three clips at the top of the panel and tilting
it toward you. Then set it aside.
clips
front panel
2. To lift the subassembly from the front of the computer,
place your thumbs under the diskette drive and grasp the top
edge of the computer with the rest of your fingers, as shown
in the following illustration. (If you have a diskette drive
installed in the lower horizontal drive bay, place your
thumbs underneath that drive instead.) Then lift up the
subassembly with your thumbs.
B-18 Installing and Removing Disk Drives