Epson Equity 286 PLUS - Manual (Page 132)

3. Lower the back of the cover onto the computer and press
down firmly on all edges of the cover to form a tight seal.
4. Turn the large screw on the back panel clockwise to secure
the cover to the computer.
5. Reconnect the computer to the monitor, printer, keyboard,
and any other peripheral devices you have. Then reconnect
the power cable to the back of the computer and to an
electrical outlet.
Post -Installation Setup for Memory Cards
After you install an optional memory card, you need to
configure your computer to use it. Follow these guidelines:
Run the SETUP program to reset your computer’s
configuration to include the memory on your memory card.
See Chapter 2 for instructions.
Use the setup program that comes with your memory card to
configure the computer for use with your particular card. See
your memory card manual for instructions. If you installed
the Rampage Plus
®
286+ card, see “Using the CORFIX
Program,” below, before running the card’s setup program.
5-42 Installing and Removing Options