Epson Equity 286 PLUS - Manual (Page 51)

Saving Your Settings
After you have made your selections for SETUP, press E SC
to
exit. You see the following prompt:
Save SETUP configuration (Y/N)?
Press E SC
to return to the menu to make corrections. Press Y
and Enter to save the settings in the CMOS RAM. Press N and
Enter to exit SETUP without saving your changes.
If you saved your changes, the SETUP program resets your
system and the computer runs through its power-on diagnostic
tests. Then you see the prompt to press
Del if you want to run
SETUP.
If something is wrong, however, you see an error message and a
prompt to run SETUP. Follow the instructions on the screen to
run SETUP again to correct it. (You may need to reset the
computer.)
If you have just run SETUP for the first time, the next thing you
need to do is install MS-DOS on your computer. See your
MS-DOS Installation Guide for instructions. (If you are using a
different operating system, follow the installation instructions
provided with it.)
2- 16 Running the Setup Program