Epson Equity 286 PLUS User Manual
Page 181
2. As
you
lower the drive onto the subassembly, guide the
ribbon cable underneath the drive.
hole
tabs in slots
As shown above, fit the tabs on the mounting plate into the
slots on the side of the subassembly. Then tilt the drive
toward the subassembly and align the retaining screw hole
on the mounting plate with the hole in the bracket.
3.
Secure the drive to the bracket with the retaining screw.
4.
To replace the subassembly, see the instructions on page
B-46.
B-42
Installing
and Removing Disk Drives