Epson Equity 286 PLUS User Manual

Page 199

Press N and

Enter

if you want the diagnostics program to

continue when an error occurs.

The next option is:

Error logging (Y/N) ?

Press

Y and Enter

to record the errors that may occur during the

test. See “Error Logging,” below, for details.

Press

and

Enter

if you do not want to create the log. (N is the

default setting.)

Note
If you press

N at the Wait

press

for

Error

error

prompt, you should

logging so you can review any errors

that may occur during the tests.

You may see a prompt requesting additional information the
program needs to perform the test(s).

If you selected Continuous testing, the diagnostics program

needs no additional information. Instead, you see this message in
the Run time parameters window:

Test mode:

Continuous

If you selected Timebound testing, you see this prompt:

Period

:00l hr 00 min

To specify the amount of time you want to run the test(s), type
the number of hours (from 000 to 999), and press

Enter.

Then

type the number of minutes (from 00 to 59), and press

Enter.

You can use the backspace key to make corrections.

Perfoming System Diagnostics

C-S