Epson Equity 286 PLUS - Manual (Page 82)

For example, to specify a page frame address 0CC000h for
EMM286.SYS, add the following command line to your
CONFIG.SYS file:
DEVICE=EMM286.SYS /M4
Note
If you have installed an EGA or VGA display adapter card,
you cannot enter the following values for n:
/ M l - M l / M 2 - M 2
The P[nnn] option specifies the number of handles (process ID S )
available to EMM286.SYS. The value for nnn must be in the
range of 64 to 256. The default value is 64.
The D option specifies whether you want EMM286.SYS to run
diagnostics on your expanded memory page frame each time you
load the program. It does not run the diagnostics unless you
include the D parameter on the DEVICE= command line.
Using the VGA Utilities
Your built-in VGA (video graphics array) display adapter
supports both standard VGA monitors and multi-frequency
monitors with analog connectors in non-interlaced mode. The
VGA adapter operates in all standard VGA resolutions without
requiring any device drivers. However, you may want to install
the VGA utilities (which came with your system on the
Reference diskette) to use some special features of your VGA
adapter.
4-10 Enhancing System
Operations