Epson Equity 286 PLUS - Manual (Page 202)

Selecting Diagnostic Tests
To start a single test, press ’ or ‘ to highlight the test category
on the Main menu. Then press ” or “ to highlight the particular
test in the submenu and press
Enter to run it.
When a test has been completed, you see this prompt:
Press to return to Main menu.
Selecting Multiple Tests
To select several tests at one time, highlight each test you want
to perform and press F3. To cancel a selection, highlight the test
and press F3 again.
You can press F4 to select all tests for all devices, and press F5
to cancel all selections.
To run the selected group of tests, press F6. The program
highlights each test name as it runs the test.
You cannot run certain tests along with other tests. The
following table lists the tests that must be run individually.
C-8 Performing System Diagnostics